TRC321B
6
6T 8085-02a
This function enables the product to be returned to its initial configuration (factory reset). After a device reset, the device can be
re-used in a new installation. A factory reset can be performed either directly on the product or by the media coupler plug-in. The
latter solution is recommended if the product is part of the installation configured by ETS, which erases the product from the
project.
• For a product which is part of the installation (known by the media coupler): In the
Physical addressing
menu, select
Factory reset
and then follow the instructions which appear on the screen,
• For a product which is not part of the installation (unknown by the media coupler): In the menu
Physical addressing
, select
RESET device out of installation
, then
Unidirectional device with Addr. button
.
It is always possible to perform the factory reset directly on the device.
Factory reset on the product:
Do a long key press (> 10 seconds) on the
cfg
push button, release the button when the
cfg
LED blinks,
Wait for the
cfg
LED to switch off, indicating that the factory reset has been completed.
Remark:
To reuse a product that has already been programmed in another installation by TX100 or quicklink
, with ETS, it is necessary to
perform a factory reset for the product.
3. Factory reset
3.1 Factory reset by ETS via the media coupler
3.2 Factory reset on the product
4. Characteristics
Product
TRC321B
Max. number of group addresses
60
Max. number of links
85
Summary of Contents for TRC321B
Page 7: ...TRC321B 7 6T 8085 02a...
