hydrostatic handle (fig 7.50, item 1), VFC lever
knobs (fig. 7.50, item 2), and panel screws (fig.
7.50, item 3). The circuit breakers are located
toward the rear of the console.
The wire harness on the diesel engine are
protected by circuit breakers mounted on the
engine (fig. 7.51).
If the circuit breaker does not reset and
continues to trip, determine the cause and correct
it.
VII.
SERVICE AND MAINTENANCE
ELECTRICAL CONTINUED
Circuit breakers handle the functions of the
heavier duty electrical circuits on the detasseler.
They trip when overloaded and automatically reset
themselves after they cool down. They will continue
to trip and reset as long as the overload or short
exists. If the circuit breaker does not reset, replace
it with the same amperage breaker only. Correct
circuit breaker location and amperage is shown in
figure 7.52.
To access the circuit breakers remove the
Circuit Breakers
x
FIG 7.51
FIG 7.50
1
2
3
3
3
3
3
3
A/C relay (cab only) ............... 30 AMP
Starter relay (diesel only) ....... 30 AMP
Lights ..................................... 40 AMP
Wire harness (diesel only) ..... 30 AMP
Wire harness (diesel only) ..... 50 AMP
FIG 7.52
MOUNTED
ON ENGINE
LIGHTS
A/C RELAY
(CAB ONLY)
30 AMP
BREAKER
WIRE HARNESS
(DIESEL ONLY)
50 AMP
BREAKER
40 AMP
BREAKER
STARTER
RELAY
(DIESEL ONLY)
30 AMP
BREAKER
WIRE HARNESS
(DIESEL ONLY)
30 AMP
BREAKER
Summary of Contents for 204
Page 133: ...x IX TROUBLE SHOOTING TASSELTROL LS SYSTEM ELECTRICAL CONTINUED FIG 9 1 1 2...
Page 134: ...x IX TROUBLE SHOOTING NOTES...
Page 140: ...138 NOTES...
Page 141: ...x...
