148
IX.
TROUBLE SHOOTING
H. HAGIE TASSELTROL
®
DISPLAY TROUBLESHOOTING
To gain further information on the status of the
Tasseltrol
®
/LS system before operation: while
sitting in the operator’s seat, turn the ignition key to
the “ON” position (do not start the engine); turn the
Tasseltrol
®
box to the “ON” position; turn the
“AUTO/MANUAL” switch to “MANUAL.”
Make sure there is nothing physically blocking
any upper or lower sensor’s path to its reflector.
The display will show the status of the upper
and lower photo sensor on each lift assembly. If the
display shows a box (“ ”) in all upper and lower
areas, the unit is ready for operation. If the display
shows a corn stalk (“ ”) in one or more areas, refer
to pages 160-161 for further suggested remedies.
The LEFT-CENTER sensors are used as
examples.
Unit rises automatically.
AUTO
MODE
MANUAL
MODE
TASSELTROL
®
DISPLAY
Lights at both photo sensors
No lights at either photo sensor
Photo sensors not in line with reflector , call
Hagie
Manufacturing Customer Service.
Faulty connector cable (See page 151, fig. 151-
1, item 2)
Faulty RED and/or BLACK wire in connector
cable (See page 151, fig. 151-1, item 1)
PHOTO SENSOR
STATUS LIGHTS
POSSIBLE
CAUSE
UPPER PHOTO SENSOR DISPLAY
L O W E R P H O T O S E N S O R
ON AUTO
ON AUTO
ON AUTO
ON AUTO
ON MAN
ON MAN
ON MAN
ON MAN
ON AUTO
ON AUTO
ON AUTO
ON AUTO
P
P
P
P
U
U
U
U
TROUBLE SHOOTING
