IV.
OPERATING SYSTEMS
36
B. HYDROSTATIC DRIVE SYSTEM
Operating The Engine
FIG. 36-1
Pre-operational Checks
Section Reference
1. Check the engine oil level. Do not oper-
ate when oil is below the low mark on
the dipstick.
2. Check the coolant level in the radiator
and the coolant overflow reservoir.
3. Check the hydraulic oil reservoir level.
4. Check the cooling air intake screen
5. Check the Filter Minder®.
6. Drain fuel/water separator.
7. Check engine drive belt.
8. Drain any water out of the air tank daily.
9. Check for any oil or fuel leaks and correct them if needed.
Start engine from operator’s seat only. When running engine
in a building, be sure there is adequate ventilation.
123
125
123
128
127
129
135
139
NOTE:
Cold oil may not flow
in quantities adequate
to prevent pump
cavitation.
BATTERY DISCONNECT-
The STS 10 SPRAYER/
DETASSELER is set up with a battery disconnect safety device (fig. 36-
1). This device is located on the left side of the rear frame cross tube.
When the key is turned to the OFF position the electrical circuit is bro-
ken therefore rendering the machine unable to
start. Do not use this device as a safety when
working on the electrical system– disconnect
the negative battery cable before servicing.
This device is also used as an anti-theft
safeguard. Keep the key in a safe place, out of
the machine when it is not in use.
OPERATING SYSTEMS
