IV.
OPERATING SYSTEMS
C. HYDRAULIC SYSTEM
DETASSELING SYSTEM
52
DEPTH COMMAND–
The depth command allows the op-
erator to adjust the depth of the LS system from the operator’s
seat. The switches are located on the combo switch panel (fig. 52
-2). They are labeled Lift 1 through Lift 6. They correspond with
the lifts from left to right
while sitting in the opera-
tor’s seat. If there are only
four lifts, the switches in the first and last positions will not control any-
thing.
To lower the cutting or pulling height, select the appropriate switch
and push down. This will extend the actuator (fig. 52-1) raising the LS
system, which in turn lowers the cutting or pulling height. To raise the cutting or pulling height, lower the LS
system by pushing the appropriate switch up.
FIG. 52-1
FIG. 52-2
OPERATING SYSTEMS
