98
V.
SYSTEM PROGRAMMING
TASSELTROL
®
TOP PARAMETER
The top parameter is used to adjust the sensi-
tivity of the top photocell. The top photocell starts
the up motion when its lights path is blocked by
corn. How much corn it has to see before starting
the up move can be changed by selecting one of
the four values
T1, T2, T3
, or
T4
. With
T1
selected,
less corn is required to start an up move. The nor-
mal or default value for this parameter is
T3
, but
can be set to any desired value.
If the pullers move up too easily when a taller
stalk of corn passes, increase the parameter to-
ward
T4
. If the pullers stay deep too long when
taller corn passes, decrease the parameter toward
T1
. Generally this parameter can be left at
T3
.
To display the top parameter, select
AUTO
and
turn the control box power on. Wait three seconds
for the
SELECT MANUAL
message. Press the
UP
button under
PAR
. Now press the
UP
button under
the
T
value.
1. The active value of the parameter is indicated
by it blinking on and off, while the other three
choices are displayed continuously.
2. To select a new value for the parameter, press
the
UP
button under the desired choice.
3. After selecting one of the four choices, press
the
LIFT 1 down
button to escape this parame-
ter.
4. To save new values and escape the parameter
mode, press the
LIFT 1 down
button a second
time.
TOP PARAMETER
SET TO T1
TOP PARAMETER SET
TO T4
TOP
BOTTOM
PHOTOCELLS
FIG 98-1
PRESS UP TO SELECT
PRESS UP TO SELECT
PRESS UP TO SELECT
PRESS UP TO SELECT
T1 T2 T3 T4
T1 T2 T3 T4
T1 T2 T3 T4
T1 T2 T3 T4
NOTE:
See page 78 for more information regard-
ing the LS photo lights.
HAGIE TASSELTROL
®
CONTINUED
SYSTEM PROGRAMMING
