VII.
SERVICE AND MAINTENANCE
A. SERVICE POINT QUICK REFERENCE CHART
SERVICE INTERVALS
Daily
1) Check engine oil (page 114)
2) Check and drain fuel filter (water separator) (page 120)
3) Check radiator coolant level (page 116)
4) Check engine drive belt (page 126)
5) Check Filter Minder
®
(page 118)
6) Check hydraulic oil reservoir level (page 114)
7) Check solution line strainer (page 120)
8) Drain wet tank and air tank (page 131)
9) Check batteries (page 124)
10) Check radiator grille screen (119)
11) Check quad puller tire pressure (page 75)
12) Grease quad puller bearings twice daily (page 123)
13) Tighten cutter blade retaining bolt (page 76)
HOURS
10
Initial checks after receiving machine
IMMEDIATELY
1) Check lug nut torque, then every 50 hours (page 127)
FIRST 50 HOURS
1) Change wheel hub oil, again at 100 hours, and then every 500 hours thereafter (page 115)
2) Change hydraulic return/suction filter, then every 250 hours thereafter (page 119 )
then
HOURS
0
HOURS
50
then
HOURS
50
HOURS
100
110
NOTES
•
*AT THE BEGINNING OF THE SEASON (YEARLY)
OR AS REQUIRED, WHICHEVER COMES FIRST
•
NOTE A
: CHECK FOR EXCESSIVE MOISTURE
•
NOTE B
: CHARGE AS REQ; USE PROPER EQUIP-
MENT
•
NOTE C
: FOLLOW FILTER MINDER READINGS
•
NOTE D
: RESET EACH TIME YOU SERVICE AIR FIL-
TER
•
NOTE E
: 1ST 50HRS, THEN 250HRS THEREAFTER
•
NOTE F
: 1ST 50HRS, THEN YEARLY
•
NOTE G
: IMMEDIATELY, THEN 50HRS THEREAFTER
•
NOTE H
: NOT RECOMMENDED
•
NOTE I
: VISUALLY CHECK THE BOLTS EVERY 50
HOURS, TORQUE CHECK THEM EVERY 100 HOURS
SERVICE AND MAINTENANCE
