5-12
SECTION 5 –
HYDRAULIC SYSTEMS
NOTE: Inspect the pressure washer hose
daily for cuts or abrasions.
To Operate the Pressure Washer
1. Ensure there is adequate amount of
water in the rinse tank.
2. Ensure the Pressure Washer wand and
hose are securely connected.
3. Engage the parking brake.
4. Start the engine.
5. Activate the Pressure Washer Pump
(located beneath platform on the rear
right-hand side of machine) by pressing
the Pressure Washer Switch (mounted
on the rear right-hand handrail) in the UP
(On) position.
NOTICE
Never run the pressure washer without
water supply. Operating without water
will cause pump failure and will void the
warranty.
Pressure Washer Wand
(Mounted on the rear right-hand handrail)
-Typical View
Pressure Washer Hose Reel
(Located near the rear
right-hand side of machine)
-Typical View
Pressure Washer Switch
(Mounted on the rear right-hand handrail)
-Typical View
Summary of Contents for STS 10
Page 290: ......
