SECTION 7 –
SPRAY SYSTEMS
7-28
8. Using a 3/4” wrench, tighten the four (4)
bolts to 68 ft.-lbs.
9. Connect the solution line with the Quick-
Connect Fitting (I) (located beneath cen-
ter of rear machine).
10. The Rear Spray Boom is now ready for
use.
Removing the Rear Boom
1. Ensure solution supply is OFF.
2. Rotate the 3-Way Boom Valve (B) to the
OFF (vertical) position.
3. Disconnect solution line from the Quick
Connect Fitting (I).
4. Remove Hairpin (H) and Bent Pull Hitch
Pin (F) and set aside.
5. Remove Rear Boom.
6. Reinstall the previously removed Hairpin
and Bent Pull Hitch Pin to the mounting
hardware.
7. Rotate the 3-Way Boom Valve (B) to
supply solution to the front boom.
SOLUTION SYSTEM
COMPONENTS
The Solution System is a constantly
monitored, continuously adjusted computer-
controlled system. The cab-mounted digital
spray system console receives information
from various inputs to help determine gallons
per acre (GPA)/liters per hectare (l/ha) and
gallons per minute (GPM)/liters per minute (l/
min).
Please read and understand the
information provided in this manual, as well
as the spray system console manufacturer’s
operation manual before operating the
Solution System. The following information
refers to components of the Solution System
and is not intended to replace the
manufacturer’s operating instructions.
•
Solution Tank
•
Solution Pump
•
Solution Pump Switch
•
Flow Meter
•
Pressure Gauge
•
Solution Tank Drain Valve
•
Solution Tank Valve
•
Main Tank Valve Switch
•
Agitation Valve
•
Agitation Valve Switch
•
Jet Agitators
•
Boom Solution Valve Switches
•
Section Indicator Display
•
Boom Solution Valve Indicators
(Transom), if equipped
•
Rate Control Switches
•
Pump Speed/Rate Switches
H
I
Summary of Contents for STS 10
Page 290: ......
