SECTION 7 –
SPRAY SYSTEMS
7-50
7. When finished rinsing the solution tank,
press the Rinse Switch to the OFF (mid)
position.
Step 2 - Spray Diluted Water
from Tank
1. Press the Agitation Valve Switch
(located on the side console) in the
DOWN (Close) position.
2. Press the Main Tank Valve Switch
(located on the side console) in the UP
(Open) position.
3. Press the Boom Solution Valve Switches
(located on the side console) in the ON
position.
NOTE: Each Boom Solution Valve Switch is
equipped with an indicator light and
will illuminate when the
corresponding Boom Solution Valve
is OFF.
4. Press the Master Spray Switch (located
on the Hydrostatic Drive Control Handle)
in the ON position.
5. Continue spraying until all diluted water
is removed from tank.
Step 3 - Rinsing the Boom and
Nozzles
1. Press the Main Tank Valve Switch
(located on the side console) in the
DOWN (Close) position.
“+” Pump Speed/Rate Switch
(Located on the side console)
-Typical View
NOTICE
Do not allow the solution pump to run dry
for a prolonged period of time. Failure to
comply may result in pump damage.
Boom Solution Valve Switches
(Located on the side console)
-Typical View
Summary of Contents for STS 10
Page 290: ......
