SECTION 8 –
MAINTENANCE AND STORAGE
8-16
3. Remove and discard used Case Drain
Filter.
4. Install new Case Drain Filter, turning
right to tighten.
5. Re-tighten Case Drain Hose.
Breather Cap
1. Loosen Breather Cap (located on top of
hydraulic oil reservoir) by turning
“counter-clockwise”.
2. Remove and discard used Breather Cap.
3. Install new Breather Cap and turn “clock-
wise” to tighten.
Strainers
(Refer to your Parts Manual for specific
location and replacement part numbers)
Strainer Basket
(Poly Tank)
Poly tanks are equipped with a Strainer
Basket (located in the top fill opening of the
tank). Inspect the Strainer Basket for debris
before using the fill opening to fill the tank.
NOTE: Only remove the Stainer Basket
when cleaning.
Tank Rinse Strainer
(Poly Tank)
Poly tanks are equipped with a mesh
Tank Rinse Strainer (located beneath center
of machine behind the solution tank). Inspect
the strainer if you are unable to obtain
adequate pressure through your rinse
system.
Case Drain Filter
(Located on left-hand side of machine)
-Typical View
Breather Cap
(Located on top of hydraulic oil reservoir)
-Typical View
Strainer Basket
(Located in the top fill
opening of the poly tank)
-Typical View
Summary of Contents for STS 10
Page 290: ......
