3-55
SECTION 3 –
CAB
•
Press the More Button to display fault
description.
•
Press the Clear Faults Button to remove
faults after the fault issue has been
resolved.
•
Press OK to confirm.
NOTE: System Faults will continue to
appear until the fault issue has been
resolved, regardless of clearing the
faults.
In the event that a severe system
malfunction should occur and cause the
machine to operate outside of normal
operating conditions (e.g. All-Wheel Steer
fault, Hydrostatic Drive Control Handle not in
neutral but has no y-axis position, tire size
not selected, etc.), a Machine Fault Warning
message will appear on the display. This
warning message will inform you that a
malfunction was detected and that the
machine is not responding normally and you
must operate with extreme caution, as
machine speed will be limited and stopping
distance may be increased or decreased.
Press OK to acknowledge.
In addition, a second warning message
will appear informing you of the specific fault
description. Contact your local John Deere
dealer for assistance.
Reversible Fan
To Activate the Reversible Fan
•
Press the Reversible Fan Button
(located on the Auxiliary Controls Page).
•
On the “Engine Fan Control” screen,
press REVERSE to turn the fan ON
(reverse).
CAUTION
Machine speed will be limited and
stopping distance may be increased or
decreased following a machine fault
warning.
CAUTION
Do not operate the machine following a
machine fault warning. Failure to comply
may result in personal injury and
machine damage.
NOTICE
Do not turn off ignition key when fan is in
reverse mode.
Machine Fault Warning
Reversible Fan Button
(Located on the Auxiliary Controls Page)
Summary of Contents for STS 10
Page 290: ......
