IV.
OPERATING SYSTEMS
4.6A
OPERATING SYSTEMS CONTINUED
AGITATION SWITCH-
The agitation switch
(fig. 4.6A-1, item A) controls the rate of flow through
the sparge system. For more information on the agi-
tation system, refer to OPERATING SYSTEMS sec-
tion D on the Spray Systems.
TANK SWITCH-
The tank switch (fig. 4.6A-1,
item B) controls the solution tank valve. This switch
must be on to spray. For more information on the
tank switch, refer to OPERATING SYSTEMS section D on the spray system.
RINSE SWITCH-
The rinse switch (fig. 4.6A-1, item C) is used when you wish to rinse the solution tank
or the booms. For more information on how to use the rinse system, refer to OPERATING SYSTEMS section
F on the rinse system.
BOOM EXTENSION SWITCH-
Boom extension (fig. 4.6A-1, item D) switches are used when folding
and unfolding the booms. Refer to OPERATING SYSTEMS section C on spray booms.
FLOAT SWITCH-
The float switch is used with the Nitrogen Tool Bar and is not covered in this manual.
WORK MODE SWITCH-
The work mode switch (fig. 4.6A-1, item F) is a safety switch. There are sys-
tems connected to this switch that will not function if the switch is not ON and this switch can not be turned on
if certain conditions exist. You can not turn the switch on if the machine is not in neutral. The switch controls
the functions of the spray system and the booms. This was set up to protect you, the operator, and others from
accidentally engaging the spray system while transporting. Be sure that this switch is on before you intend to
engage the spray system.
TREAD ADJUST SWITCH-
The tread adjust switches (fig. 4.6A-1, item G) are used to hydraulically
adjust the tread width. These switches will not do anything if you do not have hydraulic tread adjust. For more
information on hydraulic tread adjustment, refer to OPERATING SYSTEMS section C on the hydraulic sys-
tem.
FENCE ROW SWITCH-
The fence row switch (fig. 4.6A-1, item H) is for the selection of right or left
fence row spray nozzle. More information on the fence row can be found in OPERATING SYSTEMS section D
on the spray system.
BOOM SOLUTION VALVE SWITCH-
The boom solution valve switches (fig. 4.6A-1, item I) each con-
trol a valve located on the transom and the booms. The valves control the flow of solution through the boom.
The boom is broken down into 5 sections (3 sections on a 60’ boom), the far left tip being the beginning of sec-
tion one. See section D under OPERATING SYSTEMS on the spray system for more information.
A
B
C
D
E
F
G
H
I
FIG. 4.6A-1
Summary of Contents for STS 10
Page 119: ...9 9 IX TROUBLE SHOOTING NOTES...
Page 127: ...NOTES NOTES...