IV.
OPERATING SYSTEMS
4.1E
OPERATING SYSTEMS CONTINUED
E. OPERATING THE QUICK-ATTACH SYSTEM
DETACHING FROM THE MACHINE
FOLLOW THESE STEPS:
1. Determine where to place the boom once it is off the machine.
2. Lower the boom and secure the boom stands in the down position.
3. With the booms folded, horizontally extend the booms so that the
folded tip is approximately even with the rear of the cab.
4. Disengage the quick attach lock assemblies.
5. Slowly and gently lower the boom and transom assembly until the
quick attach hook is free of lock pin.
6. Make sure the solution valves are OFF and turn off the engine be-
fore disconnecting any hoses or electrical lines.
7. Once you have cleared the lock pin, unhook the hydraulic, solu-
tion, electrical, and foamer lines (if equipped), being careful not to
leave the ends in a place that they may get damaged or contami-
nated.
8. If no other attachment is going to be installed, re-lock the quick
attach lock assembly to keep it safe from damage. Be sure to
unlock it again when installing an attachment.
9. Start the machine and slowly back out and away from the boom.
Alarms will sound notifying you of modules offline, accept the
warnings.
PAGE AND FIGURE REFERENCE
4.2E
4.3E
4.4E; FIGURE 4.4E-1
4.4E; FIGURE 4.4E-2
4.4E; FIGURE 4.4E-3
4.5E; FIGURES 4.5E-1 thru 4.5E-4
FIG. 4.1E-1
Summary of Contents for STS 10
Page 119: ...9 9 IX TROUBLE SHOOTING NOTES...
Page 127: ...NOTES NOTES...
