5-10
SECTION 5 –
HYDRAULIC SYSTEMS
NOTE: As calibration cycles, the current
state will appear on the Calibration
Screen (i.e. “Not Running, “Moving
Outward”, or “Completed”).
NOTE: During calibration, the front legs will
move out first, followed by the rear
legs.
LADDER
To Lower the Ladder
•
To lower the Ladder
, move the Hydro-
static Drive Control Handle to the NEU-
TRAL position.
•
Slide the red safety lever (located on the
Parking Brake Switch) DOWN (Back)
and press top of switch DOWN.
CAUTION
Upright ladder is not a service platform
or step.
• DO NOT step on the ladder while in the
upright position.
• DO NOT lower the ladder while anyone is
on the ground near the machine.
• DO NOT attempt to lower the ladder from
ground level.
Failure to comply may result in injury.
CAUTION
Ensure the Hydrostatic Drive Control
Handle is in the NEUTRAL position
before engaging the parking brake.
Failure to comply may result in personal
injury and/or machine damage.
Hydrostatic Drive Control Handle
-Typical View
N
Parking Brake Switch
(Located near the Hydrostatic
Drive Control Handle)
-Typical View
Summary of Contents for STS 10
Page 290: ......
