SECTION 7 –
SPRAY SYSTEMS
7-2
10. Install Boom Hose Ring over top of the
hose routing.
11. Aligning Boom Hose Ring hole with the
Hose Routing Bracket hole, install bolt
(previously removed in Step 8) through
the ring and bracket. Install second bolt
to ring.
12. Hand-start nut on each bolt (as shown in
the following photo). Tighten nut with a
7/16” wrench and bolt with a 3/8”
wrench.
13. Following Steps 9-12, install second
Boom Hose Ring to additional Hose
Routing Bracket (as shown in the follow-
ing photo).
14. Repeat Steps 9-13 on opposite boom.
SPRAY BOOMS - 90/100’
-If Equipped
The spray booms are controlled by an
electro-hydraulic system. This system
consists of operator-manipulated switches
(located on the side console and the
hydrostatic drive control handle) and
hydraulic cylinders (attached to the booms),
which provide lift, level, horizontal extension,
and vertical extension.
Hose Routing Brackets (2)
(Located near the end of outer boom fold)
-Typical View
Boom Hose Ring
-Typical View
-Typical View
Boom Hose Clamp Installation
-Typical View
Summary of Contents for STS 10
Page 290: ......
