SECTION 7 –
SPRAY SYSTEMS
7-52
5. Press the Master Spray Switch (located
on the Hydrostatic Drive Control Handle)
in the OFF position.
6. Press the Solution Pump Switch (located
on the side console) in the DOWN (Off)
position.
7. When rinsing is complete, press the
Rinse Switch to the OFF (mid) position.
FOAM MARKER SYSTEM
- If Equipped
The Foam Marker system increases
efficiency in the field when spraying by
utilizing water from the rinse tank and mixing
with the foam concentrate from the foam
reservoir.
Filling the Foam Marker
Reservoir
NOTE: Foam Marker Reservoir capacity = 1
gallon (3.8 L).
1. Lift the Foam Marker reservoir fill cap
(located on top of the Foam Marker res-
ervoir fill port).
2. Fill reservoir to desired level with foam
concentrate.
3. Close fill cap when finished.
Foam Marker Operation
1. Ensure there is adequate amount of
fresh water in the rinse tank.
2. Locate the Foam Marker Switch (located
on the side console).
• Press Foam Marker Switch in the UP position if
foam application is desired from the Left Foam
Drop.
• Press Foam Marker Switch in the DOWN
position if foam application is desired from the
Right Foam Drop.
• Return Foam Marker Switch to the MID (Off)
position if no foam is desired.
CAUTION
Maximum foam regulator pressure is
20 PSI (1.4 bar). Use of higher pressure
may cause personal injury and system
damage and will void the warranty.
“+” Pump Speed/Rate Switch
(Located on the side console)
-Typical View
Foam Marker Reservoir Fill
(Located on the rear right-hand handrail)
-Typical View
• Fill
Cap
Summary of Contents for STS 10
Page 290: ......
