SECTION 9 –
MISCELLANEOUS
9-15
2. While supporting the bottom “foot” end of
boom stand, remove the Mounting Bolt
(located on the outer side of transom
frame) and slowly lower boom stand to
desired position.
3. With the boom stand at desired position,
reinstall the Mounting Bolt, ensuring the
holes of the boom stand and transom
frame are properly aligned.
4. Reinstall Lock Pin (that was previously
removed in Step 1).
5. Repeat Steps 1-4 on opposite side of
boom.
NOTE: For additional adjustment, the “foot”
end of the boom stand may also be
adjusted to best suit your situation
(e.g. boom height, ground level, etc.)
Adjust in the same manner as
previously described.
6. Reverse steps to store booms stands in
“travel” position.
AIR SUSPENSION
EXHAUST
(Air Bags)
The Air Suspension Exhaust System is
used to manually inflate/deflate the air bags
on your machine, providing you with a
smooth, consistent ride quality. It also
provides ease when connecting and
disconnecting attachments.
NOTE: Inspect air bags daily for leaks and/
or cracking.
To Inflate/Deflate the Air Bags
•
Rotate the corresponding Air Suspen-
sion Valves (located on the left-hand
front and rear air bags) in the
Lock Pin Removed
-Typical View
Mounting Bolt
(Located on the outer
side of transom frame)
-Typical View
Boom Stand
(Extended position shown)
-Typical View
• Mounting
Bolt
Summary of Contents for STS 10
Page 290: ......
