SECTION 3 –
CAB
3-62
•
Press the Machine Button (located on
the “Air Purge Settings” screen) to acti-
vate manual air purge.
NOTE: When the Machine Button is
pressed, it will open the air valve,
releasing air into the solution system.
•
Press the Master Spray Switch (located
on the Hydrostatic Drive Control Handle)
in the ON position.
•
Press the desired Boom Solution Valve
Switches (located on the side console
section keypad) to blow air and product
out of the spray system.
Automatic Mode
NOTE: Ensure the Tank Valve Selector
Switch (located on the side console)
is in the MID (Off) position, and the
Tank Rinse Switch (located on the
side console) is in the DOWN (Off)
position before activating automatic
air purge.
The system will automatically close
all valves for an automatic air purge,
but will reopen once the air purge
cycle is complete if these switches
are on.
NOTE: The agitation valve will close during
an automatic air purge, so the
operator will need to reopen the
valve if agitation is desired after an
automatic air purge. In addition, the
system will automatically switch from
“enable” to “manual” rate control, so
the operator will need to manually
“enable” the rate controller after an
air purge, machine prime, and boom
prime cycle.
To Activate the Air Purge System in
Automatic Mode:
•
Press the Air Purge/Priming Button
(located on the Main Menu).
•
Press the Machine Air Purge Button
(located on the “Air Purge/Priming
Selection” screen).
Air Purge Button
(Located on the Machine
Adjustments Screen)
Machine Button
(Located on the Air Purge Settings Screen)
Air Purge/Priming Button
(Located on the Main Menu)
Summary of Contents for STS/DPS Series
