SECTION 4 –
ENGINE AND DRIVE SYSTEMS
4-2
NOTE: Ensure that there are no other
warnings before proceeding.
2. Engage the starter.
(If the engine fails to start after 15
seconds, turn the ignition key OFF,
wait one minute, and repeat the pro-
cedure. If the engine does not start
after three attempts, check the fuel
supply system).
NOTE: Absence of blue or white exhaust
smoke while cranking indicates that
no fuel is being delivered.
3. Observe warning lights on the Machine
Display (after start-up).
NOTE: If any functions do not operate, shut
the engine OFF and determine
cause.
4. Allow a warm-up period of at least five
(5) minutes before operating the engine
at a high RPM.
NOTE: The engine must reach operating
temperature and oil pressure must
stabilize in the normal operating
range before it is run faster than idle
speed (1,000 RPM or less).
In addition to the glow plugs, your engine
is equipped with an Engine Block Heater to
aid in cold weather starting. Refer to the
engine manufacturer’s operation manual for
further information.
STS14/STS16
Your engine is equipped with an Engine
Block Heater to aid in cold weather starting.
Refer to the engine manufacturer’s operation
manual for further information.
Engine Block Heater Power Cord
- STS10/STS12
(Located beneath engine
on left-hand of machine)
-Typical View
Engine Block Heater Power Cord
- STS14/STS16
(Located beneath machine along
the right-hand side of engine)
-Typical View
Summary of Contents for STS/DPS Series
