4-17
SECTION 4 –
ENGINE AND DRIVE SYSTEMS
Drive System Control
NOTE: The NEUTRAL position must be met
before changing the direction of the
machine.
•
To move the machine forward
, slowly
push the Hydrostatic Drive Control Han-
dle FORWARD.
NOTE: The further the handle is moved
forward, the faster the machine will
travel and the engine speed will
increase.
•
To move the machine in reverse
,
slowly pull the Hydrostatic Drive Control
Handle backward.
NOTE: Machine speed is limited to 9 mph
(14.5 km/h) when in reverse.
NOTE: The farther back the handle is pulled,
the faster the machine’s speed.
•
To stop the machine
, slowly place the
Hydrostatic Drive Control Handle in the
NEUTRAL position.
NOTE: Before turning the engine off, reduce
the engine speed and allow to idle for
a minimum of three (3) minutes.
ALL-WHEEL STEER (AWS)
-If Equipped
^ Operator’s with machines equipped
with AWS pay special attention!
WARNING
Ensure the back-up alarm is audible
when operating the machine in reverse.
Shift Up/Down Switches
(Located on the side of the
Hydrostatic Drive Control Handle)
-Typical View
• Shift
UP
• Shift
DOWN
N
NOTICE
The operator can choose a minimum
level above 850 RPMs of engine speed
that they want to operate the machine
with by using the Throttle Switch.
NOTICE
Become familiar with the machine in
both coordinated and conventional
steering modes before attempting to use
the machine for its intended use.
^
Summary of Contents for STS/DPS Series
