7-2
SECTION 7 –
SPRAY SYSTEMS
Power Lines
Hagie Manufacturing Company cannot
stress enough that extreme caution must be
taken when operating equipment near power
lines. Ensure there is more than sufficient
clearance when transporting, unfolding and
folding the boom, or spraying near power
lines.
As a safety precaution, a Power Line
Warning Message will appear on the
Machine Display before extending the outer
boom extensions. Press ACKNOWLEDGE
showing that you have acknowledged that
there are no overhead power lines or
obstructions before proceeding.
Hydraulically folding the extensions of a
60/80/90-ft. or 60/100-ft. spray boom,
adjusting the spray valves, and shutting off
the outer sections essentially turns it into a
60-ft. spray boom.
Manually folding the outer extensions of a
60/80/90-ft. spray boom, adjusting the spray
valves, and shutting off the outer sections
turns it into an 80-ft. spray boom (see the
following illustrations).
Refer to the Spray System Console
calibration information provided elsewhere in
this section for further information.
WARNING
Hydraulic and electrical control systems
are optimized for use of the spray boom
attachment. Any modification to these
systems may lead to unintended and
uncontrolled motion. DO NOT install
add-on control systems that are not
approved by Hagie Manufacturing
Company.
Power Line Warning Message
(Located on the Machine Display)
60/80/90’ System with
Extensions Folded Over
60’
60/80/90’ System with Outer
Extensions Manually Folded Forward
80’
Summary of Contents for STS/DPS Series
