7-8
SECTION 7 –
SPRAY SYSTEMS
Soil/Crop Mode
Soil Mode allows the sensors to read the
height from the spray nozzles to the ground.
Crop Mode allows the sensors to read the
height from the spray nozzles to the top of
the crop canopy.
On the NORAC Monitor:
•
Press the Settings Button (wrench icon)
(located on the main “Run Screen”) to
navigate to the Settings Screen.
•
Press the cell (next to “Mode”) and
select Soil, Crop, or Hybrid.
NOTE: Hybrid Mode is an improved Crop
Mode, which uses a combination of
the crop and soil readings to improve
control. This setting is recommended
in place of Crop Mode.
Target Height
Target Height is the height you desire the
boom to be set at when spraying.
NOTE: When operating in Soil Mode, the
Target Height is measured from the
spray nozzles to the soil. In Crop
Mode, the target height is measured
from the crop canopy to the spray
nozzles.
On the NORAC Monitor:
•
Press the Settings Button (wrench icon)
(located on the main “Run Screen”) to
navigate to the Settings Screen.
•
Press the cell (next to “Height”) and
increase or decrease value to desired
boom height.
Further Information
Refer to the NORAC manufacturer’s
operation manual for complete operating/
calibration instructions, troubleshooting
information, and safety precautions.
Refer to “Specifications” provided in the
Introduction Section
elsewhere in this
manual for information on GPS dimensions
on your machine.
Enabling NORAC through the
End Row Management Switch
-If Equipped
1. Program the End Row Management
Switch (located on the Hydrostatic Drive
Control Handle) through the Machine
Display.
Refer to “Machine Display” provided in
the Cab Section elsewhere in this man-
ual for initial setup instructions.
2. Press the Settings Button (wrench icon)
(located on the main “Run Screen”) to
navigate to the Settings Screen.
End Row Management Switch
(Located on the Hydrostatic
Drive Control Handle)
-Typical View
Summary of Contents for STS/DPS Series
