7-20
SECTION 7 –
SPRAY SYSTEMS
Switch (located on the Hydrostatic Drive
Control Handle) is depressed. The switch will
toggle between the “spray” and “lifted”
positions each time that it is pressed.
A Return to Height indicator arrow
(located on the Machine Display Home Page
- Field Mode) will illuminate DOWN when in
the “spray” position, and UP when in the
“raised” position.
NOTE: If the Transom Switch (located on the
Hydrostatic Drive Control Handle) is
depressed (or Auto Fold is enabled),
the boom will resume to the “spray”
position the next time that the End
Row Management Switch is pressed.
Refer to the “End Row Management”
information elsewhere in this section for
programming Return to Height through the
End Row Management Switch.
Return to Height Settings
Lifted Height
Lifted Height is the raised boom height
position measured from nozzle to ground.
•
On the “Boom State” screen, use the
slide bar (next to Lifted Height) to adjust
to desired value.
NOTE: Swipe slide bar to the right to
increase value, or to the left to
decrease value.
Spray Height
Spray Height is the height that the
operator would like the boom to be when
spraying (nozzle-to-ground distance).
•
On the “Boom State” screen, use the
slide bar (next to Spray Height) to adjust
to desired value.
NOTE: Swipe slide bar to the right to
increase value, or to the left to
decrease value.
Return to Height Indicator -
UP
(Located on the Machine Display
Home Page - Field Mode)
Return to Height Indicator -
DOWN
(Located on the Machine Display
Home Page - Field Mode)
Lifted Height
(Located on the Boom State Screen)
Summary of Contents for STS/DPS Series
