SECTION 7 –
SPRAY SYSTEMS
7-45
NOTE: Rinse Tank Capacity = 100 gallons
(378.5 L).
1. Pull the Front Fill Release Lever (located
beneath front end of machine) OUT
(toward operator) to unlock the Front Fill
Assembly.
2. Lower the Front Fill Assembly.
3. Remove fill port cap from the Rinse Tank
Fill Port.
4. Connect operator-supplied connection to
the Rinse Tank Fill Port.
5. Rotate Rinse Tank Fill Valve to the
OPEN position and fill tank to desired
level.
6.
When finished filling the tank
, close
the Rinse Tank Fill Valve.
7. Remove operator-supplied connection
from the Rinse Tank Fill Port.
8. Reinstall the fill port cap.
9. Raise the Front Fill Assembly to the
stored position, ensuring it “clicks” into
locked position.
Rinsing the Front Fill
1. Remove Solution Tank Fill Port cap.
2. Attach fresh water supply connection to
Solution Tank Fill Port.
3. Turn fresh water supply ON.
4. Rotate the Solution Tank Fill Valve in the
OPEN position.
5.
When rinsing is complete
, turn fresh
water supply OFF.
6. Close the Solution Tank Fill Valve.
7. Remove fresh water supply connection
from the Solution Tank Fill Port and rein-
stall cap.
Side Fill
-If Equipped
NOTE: Engage parking brake before
operating the side fill.
Front Fill Release Lever
(Located beneath front end of machine)
-Typical View
Front Fill Assembly
(Lowered position shown)
-Typical View
• Rinse Tank
Fill Port
• Rinse Tank
Fill Valve
Summary of Contents for STS/DPS Series
