8-7
SECTION 8 –
DPS
Boom Solution Valve Switches (2)
(Single and Dual Product Section Keypads)
The spray booms are divided into sections
that are independently supplied with solution
and can be turned on or off individually. The
electrically-operated boom solution valves
are controlled by the Boom Solution Valve
Switches (located on the section keypad).
In
Single Product Mode
, the Single
Product Section Keypad is always used
(Primary Solution System, Sections 1-9). In
Dual Product Mode
, both Single Product
and Dual Product Section Keypads are used
(Secondary Solution System, Sections 10-
14).
•
Press the Boom Solution Valve Switches
to turn ON. Press again to turn OFF.
NOTE: Each Boom Solution Valve Switch is
equipped with an indicator light and
will illuminate when the
corresponding boom solution valve is
OFF.
NOTE: Fence Row, Rear Nozzle, Rate
Control, and Pump Speed/Rate
Switches are inactive on the Dual
Product Section Keypad.
Boom Solution Valve Switches -
Single Product Section Keypad
(Located on the side console)
-Typical View
* Used with 9-section wet boom
Boom Solution Valve Switches -
Dual Product Section Keypad
(Mounted near the side console)
-Typical View
* Used with 5-section wet boom
Summary of Contents for STS/DPS Series
