SECTION 8 –
DPS
8-22
Step 3 - Rinsing the Boom and Nozzles
1. Press the Tank Valve Selector Switch
(located on the side console) in the
DOWN (Rinse Tank) position.
NOTE: When rinsing the boom and nozzles,
ensure the Boom Solution Valve
Switches (located on the Single
Product Section Keypad) are in the
ON position before activating the
Tank Rinse Switch.
2.
When finished rinsing the booms and
nozzles
, press the Master Spray Switch
(located on the Hydrostatic Drive Control
Handle) in the OFF position.
3. Press the Solution Pump Switch (located
on the side console) in the DOWN (Off)
position.
4. Press the Tank Valve Selector Switch
(located on the side console) in the MID
(Off) position.
Dual Product Rinse
(Tanks 1 and 2)
Step 1 - Rinsing Tanks 1 and 2
1. Rotate the Dual Product Rinse Valve
(located on top of the solution tank) in
the OPEN (counter-clockwise) position.
2. Rotate the Agitation Shutoff Valve
(located beneath rear of machine) in the
OPEN (counter-clockwise) position.
3. Press the Tank Valve Selector Switch
(located on the side console) in the
DOWN (Rinse Tank) position.
NOTICE
Do not allow the solution pump to run dry
for a prolonged period of time. Failure to
comply may result in pump damage.
Tank Valve Selector Switch
(Located on the side console)
-Typical View
Dual Product Rinse Valve
(Located on top of the solution tank)
-Typical View
* Dual Product Rinse Valve
shown in the CLOSED position
Agitation Shutoff Valve
(Located beneath rear of machine)
-Typical View
* Agitation Shutoff Valve
shown in the CLOSED position
Summary of Contents for STS/DPS Series
