SECTION 8 –
DPS
8-30
11. On the drop down menu, select “Section
Test”.
NOTE: A chemical warning message will
appear on the display. Press the
Accept Button to acknowledge the
warning and continue.
12. On the Section Test Screen, check the
“Enable Pump” box and check all section
boxes, as shown in the following illustra-
tion.
13. Press the Master Spray Button to the ON
position. Press and hold the “+” button to
increase pump speed.
14. Press the Master Spray Button to the
OFF position when finished.
15.
When rinsing is complete
, press the
Tank Rinse Switch in the DOWN (Off)
position.
“Tests” Tab
(Located on the Rate
Controller Diagnostics Screen)
-Typical View
* Your machine may vary,
depending on available equipment
Drop Down Menu
-Typical View
* Your machine may vary,
depending on available equipment
Chemical Warning Message
-Typical View
* Your machine may vary,
depending on available equipment
• Accept
Button
Section Test Screen
-Typical View
* Your machine may vary,
depending on available equipment
Summary of Contents for STS/DPS Series
