SECTION 9 –
MAINTENANCE AND STORAGE
9-14
•
Remove Engine Scoop (if equipped)
from mounts and set aside.
•
Remove the two (2) Radiator Screen
Spring Clips (located on the top left and
right-hand side of screen) and set aside.
•
Extend the top of Radiator Screen out-
ward and lift the bottom of screen out of
lower pin cradles.
To Reinstall the Radiator Screen
•
At a slight angle, install the lower screen
pins into the pin cradles (located near
the bottom of the cooling pack), as
shown in the following illustration.
•
Rotate screen inward until the mounting
pins protrude through the screen.
•
Reinstall the two (2) Radiator Screen
Spring Clips.
•
Reinstall Engine Scoop and Engine
Scoop Spring Clips.
Engine Oil Filter
The Engine Oil Filter (located on the rear
left-hand side of machine below the hydraulic
oil reservoir) should be replaced every 500
hours of operation or whenever the oil is
changed, whichever occurs first.
Refer to the engine manufacturer’s
operation manual for further information and
specifications.
Radiator Screen Spring Clips (2)
(Located on the top left and
right-hand side of screen)
-Typical View
-Typical View
Summary of Contents for STS/DPS Series
