SECTION 9 –
MAINTENANCE AND STORAGE
9-18
Breather Cap
1. Shut the engine OFF.
2. Loosen Breather Cap by turning
“counter-clockwise”.
3. Remove and discard used Breather Cap.
4. Install new Breather Cap and turn “clock-
wise” to tighten.
Strainers
(Refer to your Parts Manual for specific
location and replacement part numbers)
Tank Rinse Strainer
(Stainless Steel Tank)
The stainless steel solution tank on your
machine is equipped with a mesh Tank Rinse
Strainer (located on top of solution tank).
Inspect the strainer for blockage if you are
unable to obtain adequate pressure through
your rinse system.
Case Drain Filter 1
(Located on right-hand side
of machine near batteries)
-Typical View
Case Drain Filter 2
(Located on left-hand side of
machine ahead of engine frame)
-Typical View
Breather Cap -
STS10/STS12
(Located on top of hydraulic oil reservoir)
-Typical View
Breather Cap -
STS14/STS16
(Located on rear left-hand side of
machine behind air intake filter)
-Typical View
Summary of Contents for STS/DPS Series
