SECTION 9 –
MAINTENANCE AND STORAGE
9-22
NOTE: Wear Personal Protective Equipment
(PPE) when servicing the RESPA
Cab Filtration System.
1. Turn the engine OFF.
2. Inspect RESPA Cab Filtration System for
damage.
3. Release the four (4) Filter Latches
(located on the exterior filter housing).
NOTE: Note orientation of the ejection ports.
4. Remove filter.
NOTE: When removing filter, place thumbs
on exterior filter housing hardware
for additional leverage.
5. Place used filter in a sealed plastic bag
and dispose.
NOTE: Dispose of filter according to local
regulations.
6. Wipe off any loose debris around the fil-
ter housing using a clean cloth.
NOTE: DO NOT used compressed air to
clean the filter housing.
7. Before installing the new filter, inspect
the RESPA Cab Filtration System and
replacement filter for proper operation.
8. Turn RESPA Filtration System ON, stay-
ing clear of the open end of the filter
housing.
9. Ensure adequate airflow is blowing out
of the empty filter housing.
10. Turn RESPA Filtration System OFF.
11. Install new filter.
NOTE: Ensure new filter ejection port
orientation is correct and the filter
end cap is properly seated on the
filter housing (with the gills pointing
downward to avoid water from
entering in).
12. Re-latch the four (4) Filter Latches.
Refer to your Parts Manual for
replacement part number.
NOTICE
Ensure engine is turned OFF before
servicing the RESPA Cab Filtration
System.
NOTICE
When cleaning your machine, care
should be taken to prevent high-
pressure water or air from entering the
RESPA Filtration System ejection slots.
When replacing the slotted filter, do not
point ejection slots at a solid surface in
close proximity to the slots.
Filter Latches
-Typical View
Filter Removal
-Typical View
Summary of Contents for STS/DPS Series
