SECTION 10 –
MISCELLANEOUS
10-18
Each boom stand has a leg with a “foot”
on the bottom and a hex bolt in the top hole
of the leg to secure it from sliding off, as well
as a “snap” lock pin in the hole (located
directly below the bracket) to maintain it’s
position.
120’ Hybrid Spray Booms
Your boom is featured with two (2) boom
stands that swing downward from the bottom
of the transom.
To Extend Booms Stands
1. Remove Hairpin (A) from end of Lock
Pin (B) (located on the outward side of
boom stand) and set aside.
2. While supporting the bottom “foot” end of
boom stand, remove Lock Pin (B) and
slowly lower boom stand.
3. With the boom stand lowered, reinstall
Lock Pin (B).
4. Reinstall Hairpin (A) to end of Lock Pin
(B).
Booms Stands
(90/100’ Booms)
-Typical View
Boom Stand Assembly
-Typical View
Booms Stands
-Typical View
Lock Pin Assembly
(Located on the outward
side of boom stand)
-Typical View
A
B
Summary of Contents for STS/DPS Series
