10-35
SECTION 10 –
MISCELLANEOUS
3. Align Leg Mounting Bolt and Crop
Divider Mounting Plate holes and install
bolts, tightening with a 3/4” wrench or
socket.
4. Install Crop Divider to mounting plate, as
shown in the following photo.
NOTE: Ensure the hook end of the Crop
Divider is facing outward.
5. Install two (2) Crop Divider Mounting
Bolts through Crop Divider mounting
plate and tube. Tighten with a 3/4”
wrench or socket.
6. Repeat steps to install remaining Crop
Dividers.
Installing Wheel Covers
Crop Divider Mounting Plate
-Typical View
Leg Mounting Bolts (4)
-Typical View
NOTICE
Remove two (2) lug nuts at a time from
the wheel bolts when installing the hub
cap adapter plates.
Installed Crop Divider
-Typical View
Crop Divider Mounting Bolts (2)
-Typical View
Summary of Contents for STS/DPS Series
