SECTION 3 –
CAB
3-4
Armrest Tilt Dial (D)
(Tilts armrests)
•
Roll Armrest Tilt Dial (located on each
side of operator’s seat) INWARD
(towards operator) to tilt armrest DOWN.
•
Roll Armrest Tilt Dial OUTWARD (away
from operator) to tilt armrest UP.
Height Adjustment Switch (E)
(Moves seat up and down)
•
Press Height Adjustment Switch UP to
increase seat height.
•
Press Height Adjustment Switch DOWN
to decrease seat height.
Recline Lever (F)
(Angles back rest cushion)
•
Pull and hold Recline Lever UP to adjust
back rest angle. Release lever when
desired angle is achieved.
Slide Release Lever (G)
(Moves top of seat fore/aft)
•
Pull and hold Slide Release Lever while
sliding seat forward or rearward.
Release lever when desired position is
achieved.
Thigh Tilt Lever (H)
(Tilts seat cushion up and down)
•
Pull Thigh Tilt Lever UP and hold cush-
ion to 4 degrees. Release lever
when desired position is achieved.
•
Pull Thigh Tilt Lever UP and push cush-
ion down to adjust -4 degrees. Release
lever when desired position is achieved.
Thigh Extension Lever (I)
(Extends seat cushion fore/aft)
•
Pull Thigh Extension Lever UP and hold
to adjust c/- 30 mm. Release
lever when desired position is achieved.
Armrest Height Adjuster (J)
(Adjusts armrest height)
•
Loosen two (2) bolts and move armrests
up or down.
•
While maintaining desired armrest posi-
tion, re-tighten bolts.
Fore/Aft Lockout Isolator (K)
(Locks or unlocks fore/aft isolation)
•
Pull Fore/Aft Lockout Isolator UP to
unlock isolation.
•
Push Fore/Aft Lockout Isolator DOWN to
lock isolation.
Lateral Lockout Isolator (L)
(Locks or unlocks lateral isolation)
•
Pull Lateral Lockout Isolator UP to lock
isolation.
•
Push Lateral Lockout Isolator DOWN to
unlock isolation.
Ride Firmness Lever (M)
(Adjusts ride suspension)
•
Pull Ride Firmness Lever UP for a firmer
ride.
•
Push Ride Firmness Lever DOWN for a
softer ride.
Armrest Height/Length Adjuster (N)
(Adjusts height and length of armrest)
•
Pull and hold Armrest Height/Length
Adjuster and slide forward or rearward.
Release adjuster when armrest is in
desired position.
Fore/Aft Adjustment:
+/- 76 mm at 12.7
mm increments;
Up/Down Adjustment
+/-
35 mm at 5.4 mm increments.
NOTE: Armrest tilt fixed position =
25 degrees.
Lumbar Knob (O)
(Adjusts lumbar curvature)
•
Rotate Lumbar Knob INWARD (toward
operator) for increased curve.
•
Rotate Lumbar Knob OUTWARD (away
from operator) for decreased curve.
Document Pouch (P)
(Storage for various machine manuals)
•
Pull Document Pouch Fastener to
OPEN.
•
Push Document Pouch Fastener to
CLOSE.
Seat Belt
Refer to “Seat Belt” provided in the
Safety
and Precautions Section
elsewhere in this
manual for further information.
Summary of Contents for STS/DPS Series
