SECTION 8 –
MAINTENANCE AND STORAGE
8-15
3. Install new Breather Cap and turn
“clockwise” to tighten.
Strainers
(Refer to your Parts Manual for specific
location and replacement part numbers)
Tank Rinse Strainer (Main Tank)
The stainless steel solution tank on your
machine is equipped with a mesh Tank Rinse
Strainer (located near top of the main tank).
Inspect the strainer for blockage if you are
unable to obtain adequate pressure through
your rinse system.
Solution Line Strainer
Maintain consistent application rates by
inspecting the Solution Line Strainer (located
beneath right-hand side of machine) daily for
blockage. Clean the strainer screen as needed
and ensure the gasket is in place before
reinstalling the screen.
NOTE: Wear appropriate clothing while
removing and cleaning the strainer
screen.
Rinse Tank Strainer
- If Equipped
If your machine is equipped with a foam
marker system, it will have a mesh Rinse
Tank Strainer (located near the rinse tank
outlet). Inspect the strainer for blockage if
you are unable to obtain adequate pressure.
Breather Cap Removed
-Typical View
Tank Rinse Strainer
(Located near top of main tank)
-Typical View
CAUTION
Ensure the Main Tank Valve and
Agitation Valve are CLOSED before
servicing the Solution Line Strainer.
Failure to comply may result in chemical
contact.
Solution Line Strainer
(Located beneath
right-hand side of machine)
-Typical View
Summary of Contents for STS12i Combo
Page 276: ......
