SECTION 8 –
MAINTENANCE AND STORAGE
8-29
Spray Tips
At the beginning of each season (or as
required), remove a random sample of spray
tip caps (C) and inspect the nozzle tips. If the
tips are plugged or worn, clean or replace
them. Replace spray tips every 1,000 hours of
operation, or as necessary.
NORAC
®
Sensor Foam Pads
Inspect the NORAC Sensor Foam Pads
daily. Remove the foam pad from each
sensor, blow out with compressed air, and
reinstall.
NOTE: Ensure foam pads are clean and dry
to ensure optimal performance.
NOTE: DO NOT blow the foam pad out
while still installed on the sensor.
Always remove foam pad before
cleaning to avoid sensor damage.
Replace foam pads as necessary. Contact
Hagie Customer Support for replacement.
Wiper Blade
Do not allow the Wiper Blade to run on a
dry windshield, as this will shorten the life of
the blade and/or cause scratching on the
windshield.
NOTE: Replace the windshield wiper blade
(39”/99 cm) as necessary.
The Windshield Washer Fluid Spray
Nozzle is adjustable. The fluid spray pattern
should be inspected at the beginning of each
season, and adjusted as necessary.
CAUTION
Never place a spray tip/nozzle to your
mouth in an attempt to unplug it.
Nozzle Diaphragms and Spray Tips
-Typical View
NOTICE
Use a sturdy stationary ladder to safely
access the wiper blade.
NORAC Sensor Foam Pad
(Located on the bottom of each sensor)
-Typical View
Summary of Contents for STS12i Combo
Page 276: ......