SECTION 9 –
MISCELLANEOUS
9-9
Quick Connect Multi-Coupler
-If Equipped
NOTE: If your machine is not equipped with
the Quick Connect Multi-Coupler,
proceed to the next numbered step.
• Install the Hydraulic/Electrical Connections
(located on the left-hand side of attachment) into
the Multi-Coupler Receptacle (located on front
left-hand side of machine), ensuring full
engagement.
• Push the Quick Connect Handle (located on the
Hydraulic/Electric Multi-Coupler Assembly) UP
to engage hydraulic/electrical connections.
9. Rotate the NORAC Hand Valve -
if
equipped
(located on the left and right-
hand level cylinders) in the OPEN
(counter-clockwise) position.
10. Start the engine.
11. If the air bags were previously deflated,
raise the machine by rotating the corre-
sponding Air Suspension Valves in the
CLOCKWISE (Inflate) position.
12. Press and hold the Transom Switch
(located on the Hydrostatic Drive Con-
trol Handle) in the UP position to raise
the boom until the Attachment Hooks
fully engage.
NOTE: Press and hold the Transom Switch
only until the Attachment Hooks
become fully engaged.
Electrical Snap Ring
-Typical View
Hydraulic/Electric Multi-Coupler Assembly
- If Equipped
(Located on the front
left-hand side of machine)
• Quick
Connect
Handle
NORAC Hand Valve (2) -
if equipped
(Located on the left and
right-hand level cylinders)
-Typical View
* Right-hand level cylinder shown
Summary of Contents for STS12i Combo
Page 276: ......
