SECTION 3 –
CAB
3-18
Hydrostatic Drive Control Handle
NOTE: Your machine is equipped with either
Version 1 or Version 2 of the
Hydrostatic Drive Control Handle. In
addition to difference in the
placement of controls, Version 1
allows the parking brake to engage/
disengage through the Hydrostatic
Drive Control Handle (moving the
handle fully to the right). For
machines equipped with Version 2, a
separate parking brake switch is
located adjacent to the Hydrostatic
Drive Control Handle. Refer to
specific operating instructions for
your machine.
The Hydrostatic Drive Control Handle
controls various functions of the machine and
attachments. It is used to control the direction
of the machine and the speed in which it
travels, parking brake engagement
(Version 1), and ladder extension/retraction.
It is also used to control the spray booms, end
row management, master spray, and shift up/
down speeds.
Refer to the
Engine and Drive Systems
and Spray Systems Sections
elsewhere in this
manual for further information.
Left and Right-Hand Boom Switches
The Left and Right-Hand Boom Switches
(located on the Hydrostatic Drive Control
Handle) are used to raise, lower, extend, and
retract the spray booms.
End Row Management Switch
The End Row Management Switch
(located on the Hydrostatic Drive Control
Handle) is a programmable switch that
enables various functions (i.e. All-Wheel
Power Mirror Switch
(Located on the side console)
-Typical View
• L/R Lever
• Adjust
Switch
Hydrostatic Drive Control Handle
(Version 1)
-Typical View
Front View
Rear View
Hydrostatic Drive Control Handle
(Version 2)
-Typical View
Front View
Side View
Summary of Contents for STS12i Combo
Page 276: ......