SECTION 7 –
SPRAY SYSTEMS
7-3
14. Repeat Steps 9-13 on opposite boom.
SPRAY BOOMS - 90/100’
-If Equipped
The spray booms are controlled by an
electro-hydraulic system. This system
consists of operator-manipulated switches
(located on the side console and the
hydrostatic drive control handle) and
hydraulic cylinders (attached to the booms),
which provide lift, level, horizontal
extension, and vertical extension.
Power Lines
Hagie Manufacturing Company cannot
stress enough that extreme caution must be
taken when operating equipment near power
lines. Ensure there is more than sufficient
clearance when transporting, unfolding and
folding the boom, or spraying near power
lines.
CAUTION
When operating or positioning the
booms, observe the following safety
precautions. Failure to comply may
result in injury or equipment damage.
• Do not unfold/fold boom extensions when
main boom is in cradle.
• Do not operate machine with one boom out
of cradle and the other boom in cradle.
• Ensure booms are folded and in cradle
before transporting the machine.
Boom Hose Clamp Installation
-Typical View
WARNING
When operating or positioning the
booms, observe the following safety
precautions:
• Monitor both sides of the boom during fold
procedure.
• Cradle booms when leaving the machine
unattended.
• Ensure booms are folded when cradled.
• Select a safe area before unfolding/folding
the booms.
• Clear area of personnel.
• Check for overhead obstructions.
• Do not unfold/fold booms near power lines.
Contact with power lines can result in
serious injury or death.
• Spray equipment is designed for FIELD
USE ONLY. Do not attempt to use
machinery for anything other than it’s
intended purpose.
WARNING
Hydraulic and electrical control systems
are optimized for use of the spray boom
attachment. Any modification to these
systems may lead to unintended and
uncontrolled motion. DO NOT install
add-on control systems that are not
approved by Hagie Manufacturing
Company.
Summary of Contents for STS12i Combo
Page 276: ......
