70-1
STORAGE
Preparing for Storage
1. Perform daily and weekly lubrication and
maintenance inspections as required.
2. With the engine at normal operating tempera-
ture, cycle all the hydraulic functions.
3. Thoroughly rinse the spray system. To win-
terize the spray system , it is recommended
that you use an environmentally safe type of
antifreeze and water mixture that will give
you adequate protection to –30°. Drain any
remaining solution in the spray system and
run the antifreeze mixture through the system
until it comes out all boom openings. Repeat
the above procedure with the foam marker
and the rinse systems.
4. Refer to the Raven manual for detailed infor-
mation on storage procedures for the monitor
and flow meters.
5. thoroughly wash the boom and touch up any
chipped or damaged paint. For touch up paint
recommendations, contact Hagie Customer
Service.
6. Replace any damaged or missing decals.
Warning decals and all other Hagie decals
are available through Hagie Customer Ser-
vice.
7. Use multi-purpose grease to coat exposed
hydraulic cylinder rods.
8. If the boom will be stored separately from the
sprayer, be sure that all hole openings are
capped or covered with a suitable covering.
Removing from Storage
1. Remove any dried grease from cylinder rods
and reapply if necessary.
2. Completely clean the booms.
3. carefully unseal any openings that were
sealed in the storage process.
4. Attach boom to sprayer and manually cycle
the hydraulics 2 or 3 times to thoroughly lu-
bricate components. Test the Norac system
and all of its functions according to the Norac
manual.
Summary of Contents for UpFront 120
Page 64: ...75 2 TROUBLE SHOOTING NOTES...
