IV.
OPERATING SYSTEMS
4.9
WINDSHIELD WIPER AND WASHER FLUID SWITCHES–
The windshield wiper switch (fig. 4.9-3,
item A) located on the right side of the headliner, turns on the wiper (fig. 4.9-5). The wiper will continue to op-
erate until the switch is returned to the OFF position. Replace the 39 inch wiper blade as necessary.
To activate the washer fluid pump, press the washer fluid switch (fig. 4.9-3, item B) and hold until the de-
sired amount of fluid is dispensed and then release the switch. You must turn the wiper OFF when the washer
fluid has been completely wiped away. Washer fluid reservoir is located behind the cab (fig. 4.9-4).
The fluid spray nozzle (fig. 4.9-5, item B) is adjustable. Check the spray pattern and adjust at the begin-
ning of each season or as necessary.
FIG. 4.9-3
A
B
FIG 4.9-4
A. CAB
SPRAY SYSTEM INDICATOR LIGHT–
The
spray system indicator light (fig. 4.9-1, item A) will
illuminate when the main spray control on the hydro-
static lever (fig. 4.9-2) has been activated. If the light
is not on, the spray system is not on.
MDM–
The MDM (fig. 4.9-1, item B) is also re-
ferred to as the message center. This monitor takes
the place of the conventional gauges. This monitor can give you information on tread adjust width, engine
RPM, engine oil pressure, hour meter, fuel level, coolant temperature, tire size, battery voltage, speed range,
and machine program version. The information can be viewed by using the up and down arrows to move
through it. The monitor will also display any faults found in the monitored systems.
FIG. 4.9-1
A
B
FIG. 4.9-2
FIG 4.9-5
A
B
