95
V.
SYSTEM PROGRAMMING
HAGIE TASSELTROL
®
CONTINUED
7. Set the lift down speeds:
(If you are not in parameter mode, do step one first and then do this one)
Press the
LIFT 1 up
button under the
PAR
on the
LCD display screen
six times
and the display will
show the current setting of the down speed for an
auto move*, a manual move and an all– resume
move with a value of
01
to
10.
With the value set to
03
the lifts will move a little
slower. This setting of
03
is useful for adjusting the
offset of the values for getting all the lifts the same
speed. Typically these values are set to
05
for a
fairly fast speed. The values can be changed by
pressing the up and down buttons under the
AUTO,
MAN
or
ALL
(fig. 95-1).
The values can be saved by pressing the
LIFT 1
down
button to exit this screen and save the new
parameter setting.
8. Set the lift down offset:
(if you are not in parameter mode, do step 1 first and then do this one)
Press the
LIFT 1 up
button under the
PAR
on
the LCD screen
seven times
and the display will
show the current setting of the down offset for the
first three lifts (fig. 95-2). Pressing
NEXT
again will
show the offset setting for the last three lifts.
The down offset for each valve can be adjusted
for a value from –
19
to
+20.
The more positive the
number the faster the lift will move. Typically the
offset is initially adjusted at a slightly slower speed
by setting the lift down speed to
03.
Exit the parameter mode and check the speed of
each lift by moving it manually with the up/ down
FIG. 95-1
Down Offset:
Down Offset:
Down Offset:
Down Offset:
1 2 3
1 2 3
1 2 3
1 2 3
<typical 00>
<typical 00>
<typical 00>
<typical 00>
NEXT
NEXT
NEXT
NEXT
00
00
00
00 -
-
-
-06
06
06
06
+05
+05
+05
+05
FIG. 95-2
buttons. Now correct the fastest and slowest lifts to
match the average speed by changing the offset
value with the up/down buttons for that lift while in
the
DOWN OFFSET
parameter. When finished set-
ting the offset values, return the speed setting back
to about
05.
Now with all the lifts at their highest points, select
AUTO
so all the lifts will move down together. Cor-
rect the values for any lifts that are not close to the
speed of the others.
The values can be saved by pressing the
LIFT 1
down
button to exit this screen and save the new
parameter setting.
Once the parameters have been
set, very little adjustment will be
required.
NOTE:
Down Speed:
Down Speed:
Down Speed:
Down Speed:
AUTO MAN ALL
AUTO MAN ALL
AUTO MAN ALL
AUTO MAN ALL
<typical 05>
<typical 05>
<typical 05>
<typical 05>
NEXT
NEXT
NEXT
NEXT
05
05
05
05
05
05
05
05
05
05
05
05