7-46
SECTION 7 –
SPRAY SYSTEMS
2. Rotate Solution Tank Fill Valve to the
OPEN position and fill tank to desired
level.
3.
When finished filling the tank,
close
the Solution Tank Fill Valve.
4. Remove solution supply from the Solu-
tion Tank Fill Port.
5. Reinstall fill port cap.
Filling the Rinse Tank
NOTE: Rinse Tank Capacity = 100 gallons
(378.5 L).
1. Remove fill port cap from the Rinse Tank
Fill Port.
2. Connect operator-supplied connection to
the Rinse Tank Fill Port.
3. Rotate Rinse Tank Fill Valve to the
OPEN position and fill tank to desired
level.
4.
When finished filling the tank,
close
the Rinse Tank Fill Valve.
5. Remove operator-supplied connection
from the Rinse Tank Fill Port.
6. Reinstall the fill port cap.
Rinsing the Rear Fill
1. Remove Solution Tank Fill Port cap.
2. Attach fresh water supply connection to
Solution Tank Fill Port.
3. Turn fresh water supply ON.
4. Rotate the Solution Tank Fill Valve in the
OPEN position.
5.
When rinsing is complete
, turn fresh
water supply OFF.
6. Close the Solution Tank Fill Valve.
7. Remove fresh water supply connection
from the Solution Tank Fill Port and rein-
stall cap.
Solution Tank Sight Gauge
A Solution Tank Sight Gauge is located
behind the rear left-hand side of cab to
visually check fluid level at all times from all
three fill locations.
Rear Fill Assembly
(Located behind rear left-hand wheel)
-Typical View
• Solution
Tank Fill Port
• Solution Tank
Fill Valve
Rear Fill Assembly
(Located behind rear left-hand wheel)
-Typical View
• Rinse Tank
Fill Valve
• Rinse Tank
Fill Port
