SECTION 7 –
SPRAY SYSTEMS
7-51
4. Press the Master Spray Switch (located
on the Hydrostatic Drive Control Handle)
in the ON position.
5. Continue spraying until all diluted water
is removed from tank.
Step 3 - Rinsing the Boom and
Nozzles
1. Press the Main Tank Valve Switch
(located on the side console) in the
DOWN (Close) position.
NOTE: When rinsing the boom and nozzles,
ensure the Boom Solution Valve
Switches (located on the side
console) are in the ON position
before activating the Rinse Switch.
2. Press the Rinse Switch (located on the
side console) in the UP position to rinse
the boom and nozzles.
NOTE: A Rinse Mode Indicator is located on
the Machine Display Home Page -
Field Mode and will display current
rinse mode status (TANK or BOOM).
NOTICE
Do not allow the solution pump to run dry
for a prolonged period of time. Failure to
comply may result in pump damage.
Boom Solution Valve Switches
(Located on the side console)
-Typical View
Main Tank Valve Switch
(Located on the side console)
-Typical View
Rinse Switch
(Located on the side console)
-Typical View
