SECTION 8 –
DUAL PRODUCT SPRAY SYSTEMS
8-8
The Rate Control Switches (located on
the side console) control the rate in which
solution is applied through the spray booms.
•
Press ENABLE to allow the rate control-
ler to control the application rate.
•
Press MAN (Manual) to control applica-
tion rate from the section keypad.
•
Press ENABLE and MAN to enable man-
ual rate control through the rate control-
ler.
NOTE: When “MAN” is selected, press the
Pump Speed/Rate Switches (located
on the side console) to increase (+)
or decrease (-) application rate.
Current solution pump speed is
displayed below the Solution Pump
Indicator (located on the Machine
Display Home Page - Field Mode).
Pump Speed/Rate Switches
(Used for Primary System only)
NOTE: The Dual Product System pump
speed/rate is controlled through the
spray system console.
The Pump Speed/Rate Switches (located
on the side console) control the flow rate
through the spray system.
NOTE: These switches are enabled when
the “MAN” Rate Control Switch
(located on the side console) is
previously selected.
•
Press “
+
” to INCREASE Solution Pump
speed.
•
Press “
-
” to DECREASE Solution Pump
speed.
NOTE: Increasing or decreasing pump
speed will change the application
rate through the rate controller.
Master Spray Switch
Boom solution valve switches are
controlled by the Master Spray Switch
(located on the Hydrostatic Drive Control
Handle) and must be ON to open the
electronically-operated boom solution
valves.
This allows you to turn all of the boom
solution valves on or off at the same time,
such as turning them off when you reach the
end rows, and turning them back on when
you re-enter the field.
Rate Control Switches
(Located on the side console)
-Typical View
* Used for primary system only
Pump Speed/Rate Switches
(Located on the side console)
-Typical View
* Used for primary system only
