9-19
SECTION 9 –
MAINTENANCE AND STORAGE
Cab Filters
RESPA
®
Cab Filter
NOTE: Replace the RESPA Cab Filter every
1,000 of operation or when cab
pressure drops below the minimum
pressure threshold (when cab is
sealed), whichever occurs first.
Replacing the RESPA Cab Filter
NOTE: Wear Personal Protective Equipment
(PPE) when servicing the RESPA
Cab Filtration System.
1. Turn the engine OFF.
2. Inspect RESPA Cab Filtration System for
damage.
3. Release the four (4) Filter Latches
(located on the exterior filter housing).
NOTE: Note orientation of the ejection ports.
4. Remove filter.
NOTE: When removing filter, place thumbs
on exterior filter housing hardware
for additional leverage.
5. Place used filter in a sealed plastic bag
and dispose.
NOTE: Dispose of filter according to local
regulations.
CAUTION
Do not clean or reuse filters. Failure to
comply may create health hazards.
NOTICE
Replace filter in a clean and covered
area to reduce operator and HVAC
exposure to harmful particulates.
NOTICE
Ensure engine is turned OFF before
servicing the RESPA Cab Filtration
System.
NOTICE
When cleaning your machine, care
should be taken to prevent high-
pressure water or air from entering the
RESPA Filtration System ejection slots.
When replacing the slotted filter, do not
point ejection slots at a solid surface in
close proximity to the slots.
Filter Latches
-Typical View
Filter Removal
-Typical View
