SECTION 10 –
MISCELLANEOUS
10-34
7. Install two (2) Crop Divider Mounting
Bolts through Crop Divider mounting
plate and tube. Tighten with a 3/4”
wrench or socket.
8. Repeat steps to install remaining Crop
Dividers.
Installing Wheel Covers
1. Remove two (2) lug nuts from two (2) of
the wheel bolts and set aside.
2. Install Hub Cap Adapter Plate onto the
two bolts, as shown in the following
photo.
3. Reinstall the two lug nuts onto bolts and
tighten with a 33 mm socket/air wrench.
Refer to “Service - Bolt Torque” provided
in the
Maintenance and Storage Section
elsewhere in this manual for further infor-
mation.
4. Perform Steps 1-3 to install remaining
adapter plates, ensuring only two (2) lug
nuts are removed from the wheel bolts at
one time.
5. Install the Hub Cap Adapter Weldment
onto the outside of the previously
installed Hub Cap Adapter Plates.
NOTICE
Remove two (2) lug nuts at a time from
the wheel bolts when installing the hub
cap adapter plates.
Installed Crop Divider
-Typical View
Crop Divider Mounting Bolt
-Typical View
Hub Cap Adapter Plate
-Typical View
-Typical View
