3-45
SECTION 3 –
CAB
•
Enter desired slip percentage value,
then press OK.
•
Press OK.
Slip Destroke
The percentage command that the wheel
motors will ramp up to limit hydraulic flow.
NOTE: The higher the destroke number, the
less the hydraulic flow will go to the
slipping wheel motor.
•
Press the Slip Button (located on the
Settings Page).
•
On the “Adjust Slip Parameters” screen,
press CUSTOM.
•
Press the Up/Down Arrow Buttons to
obtain desired destroke value.
NOTE: Slip Destroke values are available in
20-percent increments.
•
Press OK.
End Row Management
The End Row Management Switch
(located on the Hydrostatic Drive Control
Handle) may be programmed for use of
various functions, including All-Wheel Steer,
Auto Steer, Master Spray, and NORAC®
Enable.
NOTE: End Row Management functions are
disabled in Road Mode.
To Program the End Row Management
Switch
•
Press the End Row Management Button
(located on the Settings Page).
•
On the “Select Action to Program”
screen, select the setting in which you
wish to operate the End Row Manage-
ment Switch (located on the Hydrostatic
Drive Control Handle) - “Single Press” or
“Press and Hold”.
•
On the “End Row Management Editor”
screen, press the “+” Button and select
desired function (AWS, Auto Steer, Mas-
ter Spray, or NORAC Enable).
•
Press OK.
NOTE: Press the “-” Button to remove
function.
End Row Management Button
(Located on the Settings Page)
Select Action to Program Screen
