4-1
5
- D
A
SH
/ A
UT
O
SECTION 4 – ENGINE AND DRIVE SYSTEMS
ENGINE - STARTING
NOTE: An Insufficient Cab Air Pressure
Indicator will appear on the Machine
Display Home Page - Road or Field
Mode each time the machine is started,
due to a slight activation delay of the
RESPA
®
Cab Filtration System. The
indicator will disappear once the cab
becomes pressurized.
Pre-Operational Checklist
1. Check engine oil level.
NOTE: Do not operate the machine when oil
level is below the “L” (low) mark or above
the “H” (high) mark on the engine oil
dipstick.
2. Check engine coolant level.
3. Check diesel exhaust fluid level (Final Tier 4
engines).
4. Check hydraulic reservoir oil level.
5. Check cooling air intake screen.
6. Drain fuel/water separator.
7. Check engine drive belt.
8. Drain water out of the air tank.
9. Check for any oil or fuel leaks.
Cold Weather Starting
Your engine is equipped with an Engine Block
Heater to aid in cold weather starting. Refer to
the engine manufacturer’s user manual for
further information.
WARNING
CALIFORNIA PROPOSITION
65 WARNING
WARNING:
Diesel engine exhaust and
some of its constituents are known to the
State of California to cause cancer and
birth defects or other reproductive harm.
WARNING:
Battery posts, terminals,
and related accessories contain lead
and lead compounds, and chemicals
known to the State of California to cause
cancer and birth defects or other
reproductive harm.
CAUTION
Start engine from the operator’s seat
only. When running the engine in a
building, ensure there is adequate
ventilation.
Insufficient Cab Air Pressure Indicator
(Located on the Machine Display
Home Page - Road or Field Mode)
