Vertex III and Transponder T3 manual v.1.5 eng
© 2007 Haglöf Sweden AB
24
Quick Start Guide
Height measuring when using the transponder
1. Start the transponder and place it on the object to measure.
2. Press ON. Aim towards the transponder and press ON until the cross hair sight
goes out.
3. Aim towards the height to measure. Press ON until the cross hair sight goes out.
Repeat for taking another height.
Height measuring without using the transponder
1. Press
ON.
HEIGHT
is displayed. Press ON and
M.DIST
is displayed. Change
M.DIST
or use the current value if accurate.
2. Aim towards the height measuring point (T.HEIGHT). Press ON until the cross
hair sight goes out.
3. Aim towards the height to measure. Press ON until the cross hair sight goes out.
Repeat for taking another height.
Height measuring horizontally
1. Press
ON.
HEIGHT
is displayed. Press ON and
M.DIST
is displayed. Change
M.DIST
or use the current value if accurate and press ON.
2.
The angle window is displayed. Press left arrow and ON. Height measuring
position is featured.
3. Aim towards the height to measure. Press ON until the cross hair sight goes out.
Repeat for taking another height.
ANGLE Measuring
1. Start the Vertex with ON and use the arrow keys to reach
ANGLE.
Press ON.
2.
Sight towards the point where the angle to measure is located. Press ON until
the cross hair sight goes out.
DISTANCE Measuring (DME)
1. Start the transponder and place it on the object to where the required distance to
be measured is.
2. Press left arrow key and read the value measured.
Turn on and turn off the transponder T3
On
Keep the Vertex loudspeaker towards the transponder.
Press left arrow key until two short signals are heard from the transponder.
Off
Keep the Vertex loudspeaker towards the transponder.
Press the left arrow key until 4 short signals goes off from the transponder.
